Как войти в сервис LCD SHAPR LC-15SH1E

14-09-2006 10:43

Нужно войти в сервис и зделать сброс ошибок ламп

14-09-2006 17:52

2. Entering the adjustment processing mode
There are the following two methods.
• Setting the pin (81)(KEY4) or pin (82)(KEY5) of IC2001 (microprocessor) to GND, turn on the power.
• A "POWER" key is made on with pushing an "TV/VIDEO" and "MENU" keys at the same time.(K of the inspection
process mode is displayed by the upper left of the image plane.) → Next, "CH (Ù)" and "VOL (–)" keys are pushed
at the same time.(It becomes the image plane of the adjustment process mode.).....When it is canceled, it is made
to turn it off.(Even off in the "MAIN POWER" key, off with R/C are good.)
3.Key operation in the adjustment process mode
• The receiving channel UP/DOWN is performed with the "CH (ù)/(Ù)" keys.
One push ... The UP/DOWN tuning is performed per channel.
Continuous push ... The UP/DOWN search is performed until a next receivable station is found.
• Various adjustments
The adjustment is performed for each item by the "MENU", "Menu cursor", "CH (ù)/(Ù)" or "VOL (+)/(–)" keys
(LCD TV set and remote control).
• Adjustment item is chosen with the Menu cursor upward/downward keys.
• The adjustment item makes a toggle operation with the "MENU" key input. (Next item)
If the "MENU" key is input while the bottom item is selected, it moves to the top item on the next page.
• Press the auto preset button on the remote controller in the adjustment process mode, and the top item of the
next page will show up regardless of which item appears now.
Page 1 → Page 2 → ... → Page 66 → Page 1
• Press the manual memory button on the remote controller in the adjustment process mode, and the top item of
the same page will show up.
• UP/DOWN of each adjustment vale selected is performed with the VOL (+)/(–) keys input.

20-09-2006 13:04

kvant, данный вариант к этой модели не подходит,это на модель LC-22SV2E

21-09-2006 13:38

Вход в сервис нажать Input и V(-) и включить сеть.Выбор настроик V(-) и P(-)